Download 2015 Honda Odyssey Hood Air Deflector Installation Instructions – Installing the Hood Air Deflector 1. Open the hood. Fold back the rubber seal, and locate the four square holes on the inside of the hood. Push one grommet nut into each square hole in the hood. 2. Using an alcohol swab, clean the areas of the hood where the two brackets A and the two brackets B will mount. 3. Remove the adhesive backings from the protection films, and attach them to the front of the hood area where the two brackets A and the two brackets B will mount. 4. Slide the two brackets A and the two brackets B over the lip of the hood, and align with the holes in the grommet nuts. Loosely install a truss screw through each bracket. 5. Close the hood. Bend the three tabs on the template in the direction shown. Attach the template to the front edge of the hood on the driver’s side of the vehicle as shown. Secure the template to the hood with strips of masking tape. 6. Using an alcohol swab, clean the area where the bracket C will mount. 7. Remove the adhesive backing from the bracket C, and align it to the template secured in step 5. Remove the template. 8. Turn the template over and repeat steps 5 through 7 to install the other bracket C on the right side of the vehicle. 9. Position the hood air deflector on the hood. Align the holes in the hood air deflector with the holes in the six brackets.