Download Driver’s Seat Won’t Move Forward or Backward ’01-03 QX4 – SERVICE PROCEDURE 1. Using the power seat switch, tilt the front edge of the seat bottom all the way up. 2. Check voltage to the seat slide motor as follow: • Measure voltage between terminal 1 (“BR” wire) and terminal 2 (“W/B” wire) in the seat slide motor connector (B518). • See Figure 2. For more detailed information, refer to “Automatic Drive Positioner” in the EL section of the appropriate Service Manual (ESM). WARNING: When checking the power seat slide motor circuit, do not confuse its black connector (B518) with the side air bag module yellow connector. • This voltage check can be done with the seat slide motor connected. • If the voltage is about 12V when the seat slide switch is pressed to the “forward” and “backward” positions this bulletin applies, proceed to step 3. • If voltage is 0V when the seat slide switch is pressed to either the “forward” or “backward” positions, this bulletin does not apply. Use the EL section of the appropriate Service Manual (ESM) to further diagnosis and repair the incident. 4. Lightly tap the seat slide motor (see Figure 2 on page 2). Sometimes this will get the motor working again temporarily so the seat can be moved to access the seat mounting bolts.