Home Auto Repair 2015 Honda Odyssey Roof Rails Installation Instructions

2015 Honda Odyssey Roof Rails Installation Instructions

89

Download 2015 Honda Odyssey Roof Rails Installation Instructions – Installing the Roof Rails 1. Remove the left roof molding by carefully lifting it upward from four roof molding clips. 2. Open the tailgate halfway. Using a trim tool, pry up on the rear end of the roof molding left cover. 3. While wearing an eye protection, use an air saw to cut off the roof molding left cover at the scribe line as shown. Remove any burrs. 4. Remove and discard four roof molding clips from the roof molding or the stud bolt on the roof. 5. Remove any excess sealant from the stud bolts. 6. Measure and use a felt-tip pen to mark the left roof molding as shown. 7. While wearing an eye protection, use an air saw to cut off the left roof molding at the mark made in step 6. 8. Install one roof molding clip to the left roof molding (front). 9. Reinstall the roof molding left cover. NOTE: If the roof molding cover is not even with the roof, it is installed incorrectly. Reinstall the roof molding cover properly. 10. Reinstall the left roof moldings back onto the roof of the vehicle as shown. 11. Install the left side roof rail with six Torx nuts. Make sure the roof rail is installed in the correct position. Torque the Torx nuts to: 10 N·m (1.0 kgf·m, 7.3 lbf·ft) 12. Install the left front roof rail cover to the left side roof rail with two clips. 13. Secure the left front roof rail cover to the left side roof rail with one Torx screw.