Home Auto Repair 2015 Honda Pilot 18′ Aluminum Wheel Installation Manual

2015 Honda Pilot 18′ Aluminum Wheel Installation Manual

97

Download 2015 Honda Pilot 18′ Aluminum Wheel Installation Instructions – 1. Using isopropyl alcohol on a shop towel, clean the area where the center cap emblem will attach. 2. Remove the adhesive backing from the center cap emblem. 3. Attach the center cap emblem to the wheel center cap by aligning its pins with the holes in the wheel center cap. After attaching, hold the emblem firmly against the wheel center cap with the palm of your hand for 30 seconds. 4. Slide the two push nuts onto the two pins. Note the direction of the push nuts. 5. Before installing the tire pressure sensor, clean the mating surface on the sensor and the aluminum wheel. 6. Install the tire pressure sensor and the washer on the aluminum wheel, and tighten the valve nut finger tight. Make sure the pressure sensor is resting on the wheel. 7. Tighten the valve nut to the specified torque while holding the tire pressure sensor toward the wheel. Tightening torque: 4 N·m (3 lbf·ft) 8. Install the tires according to the instructions in the service manual. 9. Install the wheels on the vehicle and torque the wheel nuts to 127 N·m (95 lbf·ft). 10. Using the HDS, memorize the tire pressure sensor ID according to the instructions in the service manual. 11. Open the driver’s door. Using isopropyl alcohol, thoroughly clean the area where the new tire pressure information label will attach.