Download 2015 Honda Pilot Premium Running Boards Installation Instructions – 1. Install the rivet nut to the vehicle frame as shown. • Thread the rivet nut onto the mandrel of the rivet nut tool as shown. • Insert the rivet nut into the hole in the vehicle frame and install the hex wrench on the rivet nut tool. • While holding the rivet nut tool with the hex wrench, use a 27 mm wrench to turn the tool clockwise to install the rivet nut into the hole in the vehicle frame. • Remove the rivet nut tool from the rivet nut by turning the hex wrench counterclockwise. 2. Position left bracket A onto the vehicle frame in the area shown, and loosely install it using two flange bolts. Do not tighten the flange bolts at this time. Make sure the flange bolts are installed into the correct locations. 3. Position the two left brackets B onto the vehicle frame in the areas shown, and loosely install them using two flange bolts for each braket. Do not tighten the flange bolts at this time. Make sure the flange bolts are installed into the correct holes. 4. Slide three square head bolts into each groove on the bottom of the premium running board. 5. Position the premium running board onto the left brackets, align the square head bolts with the holes in the brackets and loosely install the six flange nuts. Do not tighten the flange nuts at this time.