Home Auto Repair Toyota Oil Filter Cap Assembly Precautions

Toyota Oil Filter Cap Assembly Precautions

102

Download Toyota Oil Filter Cap Assembly Precautions – Applicability 2007 – 2010 Toyota Tundra, Camry, Corolla, Matrix, Highlander, RAV4, Venza, Land Cruiser, Sequoia. Repair Procedure NOTICE During oil filter replacement: • Ensure that SST 09228-06500-02 or 09228-06501 is used to remove and install the oil filter cap — or damage to the cap may occur. • Inspect the SST for any damage or distortion before use. • Confirm that the SST is fully seated on the oil filter cap when removing/installing (see Figure 1). • Ensure a torque wrench is used for oil filter cap installation. Torque: 25 +/- 5 N*m (255 +/- 51 kgf*cm, 18 +/- 3.7 ft*lbf) • There is a possibility the oil filter cap will be difficult to remove if the torque range is exceeded. FAILURE TO FOLLOW THE INSTRUCTIONS ABOVE MAY RESULT IN OIL FILTER CAP AND/OR SST DAMAGE. Refer to the Technical Information System (TIS) when replacing the oil filter, applicable model and model year Repair Manual:… To prevent damage to the oil filter cap assembly, this procedure must be closely followed during oil filter replacement to avoid immediate and future oil filter serviceability concerns. The following engines are equipped with a plastic oil filter cap assembly: • 1UR-FE (Tundra, Sequoia) • 3UR-FE (Tundra, Sequoia, Land Cruiser) • 2ZR-FE (Corolla, Matrix) • 1AR-FE (Highlander, Venza) • 2AR-FE (RAV4, Camry)