Home Auto Repair 2014 Toyota Highlander Mudguards Installation Manual

2014 Toyota Highlander Mudguards Installation Manual

135

Download 2014 Toyota Highlander Mudguards Installation Instructions – 1. Clean mudguard mounting areas. (a) clean and degrease front and rear body Panels where mudguard is to be located using Vdc approved cleaner and cleaning method. 2. Installation of front mudguard. (a) starting with the passenger side front wheel Well, remove the two hex head screws and Retain (fig. 2-1). (b) using the nylon pry tool, remove and retain The vehicle’s bottom plastic fastener as Shown (fig. 2-2). (c) position front mud guard in place and align The three mounting locations. Insert the Vehicle’s plastic fastener removed in step 2b Into the bottom mount location. Ensure Fastener body is fully seated and depress Center pin fully until it locks into place (fig. 2-3). (d) using the two screws removed in step 2a, Install the top screw first. Push mudguard Tightly against fender and tighten. Then Install the (2nd) lower screw. Push mudguard Tightly against fender and tighten (fig. 2-4). Note: if necessary turn the steering wheel To make it easier to work inside the tire area. (e) fully tighten the screws so they will not Become loose. (f) repeat above steps for driver side. 3. Installation of rear mudguard. Starting with the passenger side, locate the two Bolts shown behind the rear wheel as shown in Fig. 3-1. (a) remove and retain the bolts behind the rear Wheel well (fig. 3-1).