Home Auto Repair Harley Davidson Billet Clutch Cable Adjuster Cover Kit Installation

Harley Davidson Billet Clutch Cable Adjuster Cover Kit Installation

80

Download Harley Davidson Billet Clutch Cable Adjuster Cover Kit Installation Manual 1. Dyna Models: Remove the plastic clip that fastens the clutch cable to the frame downtube just below the clutch cable adjuster and boot. Leave the clip above the adjuster in place. Softail Models: Remove the plastic clip and screw that attaches the clutch cable to the frame downtube just above the clutch cable adjuster and boot. 2. ALL Models: See Figure 1. Cut the original rubber boot (B) from the clutch cable (A). Make sure that the clutch cable covering is not cut or damaged. 3. Obtain the two halves of the clutch cable adjuster cover (items 1 and 2) and two cushions (8). Peel the paper backing from one cushion (8), and center the cushion on the inside of one cover half. Repeat for the other cushion and cover half. 4. Obtain the two screws (7) from the kit. Position the cover halves on each side of the cable adjuster, and align the screw holes at each end. Place a drop of Loctite 243 – Blue on the screw threads, and fasten the cover halves with the two screws. Tighten to 21 in-lbs (2.4 Nm)