Home Auto Repair 2017 Acura MDX Cargo Net Installation Instructions

2017 Acura MDX Cargo Net Installation Instructions

224

Download 2017 Acura MDX Cargo Net Installation Instructions – 1. Pull each lever, and fold down the left and right third row seats. 2. At the rear of the left rear side trim panel, use your finger to locate the pre-drilled hole in the panel under the carpet. 3. While wearing eye protection, drill a 14 mm hole in the left rear side trim panel: • Wrap tape around an 8 mm and a 14 mm drill bits, 10 mm (0.4 in.) away from the tip, or use a drill stop. • First drill with an 8 mm drill bit, and finish with a 14 mm drill bit. • Remove any burrs. 4. Thread one bolt into one anchor. 5. Thread the anchor into the 14 mm hole you drilled. Adjust the anchor to the horizontal position. 6. Repeat steps 2 through 5 to install an anchor on the right side of the vehicle. Installing the Cargo Net The cargo net can be installed in two positions. Horizontal Position : • Attach four snaps to the cargo net at the loops shown. • Attach four snaps from the cargo net to the cargo hooks shown.