Download 2017 Acura MDX Front and Rear Parking Sensors Installation Instructions – Removing the Vehicle Parts 1. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the air intake tube. • Disconnect the negative cable from the battery. 2. Remove the front bumper: • Apply masking tape as shown on each side. • Remove the air intake guide. • Remove the four self-tapping screws, the two push rivet clips, the four clips, the four short clips, the four washer-bolts, and the four flange bolts. • Release the three retaining tabs on each side. • With the help of an assistant, release the four retaining tabs on each side. • With the help of an assistant, release the front bumper. Place the front bumper on the blanket to prevent damage.