Home Auto Repair 1984-1998 Jeep Wagoneer/Commando/Cherokee Headlights REMOVAL & INSTALLATION HEADLIGHT AIMING

1984-1998 Jeep Wagoneer/Commando/Cherokee Headlights REMOVAL & INSTALLATION HEADLIGHT AIMING

228
Download Cherokee, Wagoneer and Comanche Models See Figures 1, 2, 3, 4, 5, 6 and 7 Fig. Fig. 1: Remove the top corner headlight bezel mounting screw Fig. Fig. 2: To access the turn signal bulb or headlight bezel mounting screws, remove the 2 turn signal housing retaining screws Fig. Fig. 3: After removing the turn signal housing from the headlight bezel, remove the 2 bezel mounting screws … Fig. Fig. 4: … then carefully pull the headlight bezel away from the headlight assembly Fig. Fig. 5: Remove the 4 headlight assembly retaining ring screws … Fig. Fig. 6: … then pull the retaining ring off of the headlight assembly Fig. Fig. 7: Pull the headlight assembly away from the vehicle just far enough to disengage the electrical connector from behind the headlight 1. Remove the headlamp bezel and retaining ring attaching screws. Remove the bezel and retaining ring. 2. Pull the headlight out, disconnect the wire harness and remove the headlight from the vehicle. 3. Install the headlight in the reverse order of removal. Grand Cherokee and Grand Wagoneer Models 1. Open the hood, reach into the engine compartment and locate the lock ring supporting the bulb assembly.