Download REMOVAL 1. Lift up the vehicle and remove the wheel and tire. Disconnect the wheel speed sensor from the knuckle. 3. Disconnect the brake hose from the knuckle. 4. Remove the caliper assembly and suspend it with wire. 5. Remove the split pin and drive shaft nut from the front hub. 6. Remove the 2 bolts and disconnect the ball joint from the knuckle. 7. Using a plastic hammer, disconnect the drive shaft from the axle hub. 8. Using the special tool, disconnect the tie rod end from the knuckle. NOTE: 1) Be sure to tie a cord to the special tool and to a nearby part. 2) Loosen the nut but do not remove it. 9. 10. 11. 12. Loosen the upper arm mounting nut but do not remove it. Using the special tool, disconnect the upper arm from the knuckle. Remove the front axle and knuckle together. Installation is reverse of removal. DISASSEMBLY 1. Remove the brake disc from the hub. 2. Remove the snap ring. 3. Using the special tool, disconnect the hub from the knuckle. 5. Using the special tool, remove the wheel bearing outer race from the knuckle.