Home Auto Repair 2001 Ford Taurus Engine Cooling Water Pump REMOVAL AND INSTALLATION

2001 Ford Taurus Engine Cooling Water Pump REMOVAL AND INSTALLATION

184
Download Water Pump — 3.0L (2V) Removal 1. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding in this section. 2. Loosen the water pump pulley. 3. Remove the accessory drive belt. For additional information, refer to Section 303-05. 4. Remove the degas bottle. For additional information, refer to Degas Bottle in this section. 5. Disconnect the battery ground cable. For additional information, refer to Section 414-01. 6. Disconnect the generator B+ cable and the voltage regulator electrical connector. 7. Remove the nut, the bolt and the generator brace. 8. Remove the generator mounting bolt and the generator. 9. Remove the bolt and the nut, and position the roll restrictor bracket out of the way. 10. Remove the bolt and the accessory drive belt tensioner. 11. Remove the nut, the bolt and the support bracket. 12. Remove the bolts and the water pump pulley. 13. Disconnect the water pump inlet hose and the crankshaft position sensor electrical connector.