Home Auto Repair 2006 Ford Fusion Wheel Knuckle REMOVAL AND INSTALLATION

2006 Ford Fusion Wheel Knuckle REMOVAL AND INSTALLATION

71
Download Special Tool(s) Remover, Front Hub 205-D070 (D93P-1175-B) or equivalent Remover, Steering Arm 211-003 (T64P-3590-F) Remover, Tie-Rod End 211-105 (T85M-3395-A) Separator, Ball Joint 204-592 Adapter for 204-592 204-592/1 Installer, Halfshaft 204-161 (T97P-1175-A) Removal NOTICE: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts. 1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. 2. If equipped, remove the wheel speed sensor bolt. 3. If equipped, remove the wheel speed sensor harness bolt and position the wheel speed sensor aside. 4. NOTE: Apply the brake to keep the halfshaft from rotating.