Download 1. Disconnect the battery ground cable. For additional information, refer to Section 414-01. 2. Remove the air cleaner outlet tube. For additional information, refer to Section 303-12. 3. Remove the accelerator cable snow shield. 4. Disconnect the accelerator cable from the speed control actuator cable (if equipped) and position aside. 5. Loosen the bolt and slide the engine control wiring connector off the bracket. 6. NOTE: Spark plug wires must be connected to the correct ignition coil terminal. Mark spark plug wires before removing them. Disconnect the spark plug wires from the ignition coil. 7. Disconnect the ignition coil and the radio ignition interference capacitor electrical connectors. 8. Disconnect the throttle position (TP) sensor electrical connector. 9. Disconnect the idle air control (IAC) electrical connector. 10. Disconnect the brake booster vacuum hose, the positive crankcase ventilation (PCV) hose, and the vacuum hose.