Home Auto Repair MITSUBISHI GALANT SEDAN 2.4L SINGLE EXHAUST INSTALLATION STEPS

MITSUBISHI GALANT SEDAN 2.4L SINGLE EXHAUST INSTALLATION STEPS

60
Download 1) Lower exhaust by removing bolt in rear rubber hanger. Remove exhaust hear shield. 2) Fishwire the 1/2″ bolt and into position using access hole as shown. NOTE: Fishwire bolt through frame on inside of frame rail. 3) Place U-bolts into position as shown in the above diagram. 4) Raise hitch into position, being carefull not to push fasteners into frame. 5) Attach hitch with remaining fasteners as shown. 6) Torque all 1/2″ fasteners to 75 lb-ft, and all 3/8″ fasteners to 30 lb-ft. 7) Re-install heat shield. Raise exhaust into position, and re-install original bolt. PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.