Download Special tools, testers and auxiliary items required Thrust Plate VW 401 Thrust Plate VW 402 Assembly Tool T10065 Tube 37mm dia. VW 416 B Punch VW 411 Thrust Pad VW 447 H Special tools, testers and auxiliary items required Assembly/removal tool T40018 Disassembling Clamp drive shaft horizontally into vise. Note: Use protective jaws. Make sure the drive axle is not damaged. Mark position of joint piece to drive axle. If installation positions are not marked and components are not reinstalled in previous positions, noises may occur later during driving operation. A water-proof felt pen is well-suited for marking. Remove clamps – arrows – . Slide back CV boot. Guide Assembly/Removal tool T40018 in behind joint piece. Guide pin – 1 – must make contact with exterior of joint piece. Bring Assembly/Removal tool T40018 into contact at joint piece by turning knurled bolt – 2 – . Note: Joint piece must be secured in Assembly/Removal tool T40018 without play. Only hand tighten bolts – 2 – . Screw Slide Hammer-complete Set VW 771 into Assembly/Removal tool T40018 . Pull off joint piece horizontally using Slide Hammer-complete Set VW 771 . Keep joint piece in Assembly/Removal tool T40018 .