Home Auto Repair How to remove and Install Oil Pan Subaru Legacy Outback 1998 :...

How to remove and Install Oil Pan Subaru Legacy Outback 1998 : Download

103
Download REMOVAL 1) Remove front wheels. 2) Remove air intake duct. 3) Disconnect connector from front oxygen sensor. 3) Disconnect connector from front oxygen sensor.4) Disconnect connector from rear oxygen sensor, (California 2200 cc model only) 5) Remove pitching stopper. 6) Remove radiator upper brackets, 7) Support engine with a lifting device and wire ropes. 8) Lift-up the vehicle. CAUTION: At this time, raise up wire ropes. 9) Drain engine oil. Set container under the vehicle, and remove drain plug from oil pan. 10) Disconnect connector from rear oxygen sensor. (Except California 2200 cc model) 11) Remove front exhaust pipe. a) b) c) Separate front catalytic converter from center exhaust pipe. Remove front exhaust pipe from engine. Remove bolt which installs front exhaust pipe on bracket. 12) Remove nuts which install front cushion rubber onto front crossmember. 13) Remove bolts which install oil pan on cylinder block while raising up engine.