Home Auto Repair 1995 Saturn Wagon Clutch Slave Cylinder: Service and Repair

1995 Saturn Wagon Clutch Slave Cylinder: Service and Repair

128
Download Hydraulic Clutch Control System IMPORTANT: The clutch hydraulic system is to be serviced as a COMPLETE UNIT!!!. It is a sealed unit and has been filled with fluid and bled of air at the factory. Individual components of the system are not available for service, except the slave cylinder actuator pushrod plastic retainer strap. Do not attempt to bleed the clutch hydraulic system. The bleed screw located on the clutch hydraulic slave cylinder is used for the factory fluid fill only. WARNING: Do not attempt to bleed the clutch hydraulic unit. Any observed fittings are there for factory use only. The unit comes as a complete pre-bled unit. REMOVAL 1. 2. 3. 4. 5. 6. 7. Block clutch pedal up to prevent pedal from being depressed with slave cylinder removed from transaxle. Remove air induction system. Disconnect negative battery cable from battery. Disconnect positive battery cable from battery Remove hold-down retaining nut and screw, and lift off battery hold-down retainer. Lift the battery of vehicle, and place in a safe location. Remove battery tray bolts and tray. IMPORTANT: One bolt is located in the fender well. NOTICE: