Download REMOVAL OF STOCK EXHAUST SYSTEM: Put the vehicle onto a car lift. WARNING: make sure, that car lifting is safely and correctly done or you risk vehicle damage, injury or even death! 1. Mark the muffler inlet pipe 60mm from the edge of the muffler, as shown in figure. Cut pipe with angle grinder or equivalent (Figure 1). 2. Pull the vacuum tube off the exhaust valve cylinder (Figure 2). 3. Unscrew the marked bolts and nuts on both sides of the vehicle. Remove the muffler with rubber brackets from the vehicle (Figure 3, 4). INSTALLATION OF THE AKRAPOVI? EXHAUST SYSTEM: 1. Attach the stock rubber brackets on both sides of the Akrapovi? muffler as shown (Figure 5). INSTALLATION TIP: for easier mounting, lubricate the stock rubber brackets. 2. Assemble the clamp onto the inlet of the mufflers, as shown (Figure 6). WARNING: use anti-seize copper paste on clamp bolt threads. 3. Assemble the clamps and sferical rings onto the Tail Pipes (Figure 7) 4. Install the plastic plug and plastic tie (supplied in the Akrapovi? installation kit) into the vacuum cylinder tube and secure the tube as shown (Figure 8).