Download IGNITION LOCK CYLINDER REMOVAL 1. Disconnect the battery ground cable. 2. Remove the instrument panel lower panel. 1 Remove the screws. 2 Release the fastener. 3. Detach the steering column upper shroud. Using a thin bladed screwdriver, release the two clips (one each side). 4. Remove the audio control switch (if equipped). 1 Using a thin bladed screwdriver, release the locking tang. 2 Disconnect the electrical connector. 5. Remove the steering column lower shroud. 1 Release the steering column locking lever. 2 Remove the screws. Remove the ignition key. 6. Remove the ignition lock cylinder. 1 Insert and turn the ignition key to position I (Accessory). 2 Using a thin bladed screwdriver, depress the detent. 3 Remove the lock cylinder. INSTALLATION 1. To install, reverse the removal procedure.