Download SYMPTOM The blower motor doesn’t work at all. PROBABLE CAUSE Poor connection at the blower motor caused by stress on the wiring harness. CORRECTIVE ACTION Install a blower motor sub harness. REPAIR PROCEDURE 1. Remove the glove field and cover: • 1999-03 3.2 TL: See web page 20-66 of the 1999-03 3.2 TL Service Manual. • 2001-03 3.2 CL: See page 20-sixty four of the 2001-03 3.2 CL Service Manual. • On-line, enter key phrase GLOVE, and choose Glove Box Removing/Set up from the list. 2. Disconnect the brown 7P connector (C202) from the principle harness. Remove the YEL/BLK wire terminal from cavity 3 of connector C202. Lower off the terminal, and tape the remaining finish of the wire to the harness. NOTE: If obligatory, seek advice from the terminal substitute part of the appropriate ETM for the right way to properly take away a terminal from a connector.