Download 1. Remove the battery. For additional information, refer to Section 414-01. 2. Disconnect the mass air flow (MAF) sensor. 3. Disconnect the breather tubes. 4. Remove the engine air cleaner. 5. Remove the air filter assembly. 6. Remove the battery tray. 7. Disconnect the connectors. 8. Remove the electrical connector and the wiring harness from the bracket. 9. Remove the manual control lever cable. 1. Remove the nut. 2. Remove the shift actuator cable fitting from the shift cable and bracket. 10. Disconnect the power steering sensor connector. 11. Disconnect the power steering harness and output shaft speed (OSS) sensor connector. 12. Disconnect the wiring harness from the shift cable bracket. 13. Disconnect the turbine shaft speed (TSS) sensor. 14. Remove the bolt from the coolant pipe bracket. 15. Remove the nut from the coolant pipe bracket. 16. Remove the bolts. 17. Remove the nut for the cooling tube. 18. Install the engine lifting bracket. 19. Remove the upper cowl assembly. 1. Remove the wiper. 2. Remove the clips.