Home Auto Repair 2002-2004 Honda Cr-V Fog Light Draft Copy Installation Instructions

2002-2004 Honda Cr-V Fog Light Draft Copy Installation Instructions

135

Download INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” NOTE: These installation instruction show the left fog lightbegin installed. The same procedure applies to installing the right fog light. 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. 3. Open the hood. Loosen the battery bracket nut. Remove the radiator cover (seven clips and one bolt). 4. Remove the four clips, four bolts, and two self- tapping screws that fasten the front bumper. Remove the front bumper. 5. Using masking tape, mask the bumper around the fog light opening. 6. Using a utility knife, slowly and carefully cut out the fog light opening. Be sure to cut your lines as straight as possible, and do not damage the bumper. Remove any burrs from the edges of the fog light grille opening with a file. 7. Attach the rubber trim to the edge of the fog light opening. 8. Position the left fog light adjuster on the left fog light, and install the one step screw and one 4 x 8 mm washer-screw. 9. Position the bottom hole of the fog light bracket on the left fog light, and install the one step screw.