Home Auto Repair 2000-2002 FORD FOCUS ZX3 AVENGER BODY KIT INSTALLATION INSTRUCTIONS

2000-2002 FORD FOCUS ZX3 AVENGER BODY KIT INSTALLATION INSTRUCTIONS

82

Download Cleaning procedure using a paper towel and grease remover or lacquer thinner, thoroughly clean area on car where the double face tape will come in contact with the painted surface. Do not allow thinner or cloth to remain on car too long as it can cause damage to the painted surface. Using either of the recommended adhesion promoters on a clean lint free cloth, apply a thin, uniform coating to the bonding surface, using the minimum amount that will fully coat the surface. Allow promoter to dry completely before attempting installation of the part. 1) front bumper replacement open the hood and remove the factory clips along the center of the factory front bumper. Remove one screw in each wheel well and also remove the two ten millimeter bolts located on the underside of the bumper. Remove the factory front bumper and discard the styrofoam absorber. Remove the grill from the factory bumper and place it on the new wings west front bumper. Note the location of the holes on the factory bumper. Using this as a template, drill holes in the new wings west bumper in the same locations. Place the bumper on the car and replace the factory clips along the top of the new wings west bumper replacement.