Download INSTALLATION 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Close the sunroof. 3. Disconnect the negative cable from the battery. 4. Insert a flat-tip screwdriver wrapped with a shop towel into the groove of the instrument panel and release two clips. Pull the instrument panel out toward you to release eighteen clips, and remove the instrument panel by unplugging the vehicle connectors. 5. Remove the audio unit (five screws, and pull the audio unit out toward you, and unplug the vehicle connectors). 6. Remove the driver’s console side trim (three retaining clips and one tab). 7. Remove the passenger’s console side trim (two retaining clips and one tab). 8. Remove the dashboard center lower cover: • Remove the center pocket. • Remove the three self-tapping screws. • Release the five retaining clips and six retaining tabs, and pull out the dashboard center lower cover. • Unplug the vehicle connectors, and remove the dashboard center lower cover. 9. Remove the glove box: • Open the glove box. Disconnect the damper arm. • Remove the stoppers (two retaining tabs for each stopper). • Remove the two screws. 10. Remove the right dashboard side cover (seven clips). 11. Remove the front center tray (two clips and two hooks). 12. Remove the center console rear cover : • Pull the center console rear cover out toward you to release eight clips. • Slide the vehicle console light connector and the vehicle connector, and remove the vehicle console light connector and the vehicle connector from the vehicle clips.