Home Auto Repair LED Harley-Davidson Replacement Fog Lights Installation

LED Harley-Davidson Replacement Fog Lights Installation

206

Download LED Harley-Davidson Replacement Fog Lights Installation – 1. First remove the set screw located on the bottom of the trim ring that holds the fog light in. Carefully lift the fog light out of the motorcycle as you disconnect the wires. 2. Remove the inner retaining ring located behind the lighthead and discard or save it. This retaining ring will not be used in this installation. 3. Attach the foam gasket to the LED lighthead as shown, leaving a gap on the bottom for drainage. 4. Connect the wires of new lighthead to the existing motorcycle wires. RED = +12 Volts BLACK = Ground 5. Insert the lighthead into the mounting hole of the fog light and secure it by re-installing the trim ring. 6. Test the lightheads operation and installation is complete. IMPORTANT! Before returning this vehicle to active service, visually confirm the proper operation of this product, as well as all vehicle components/equipment