Home Auto Repair 2012 Honda Ridgeline Door Visor Installation Instructions

2012 Honda Ridgeline Door Visor Installation Instructions

155

Download Installing the Front Door Visor 1. Lower the front door glass completely. Remove the door glass run channel from the door sash in the area shown. Do not remove the glass run channel from the door mirror base. 2. Using isopropyl alcohol on a shop towel, clean the shaded area of the door sash. 3. Locate the door sash in the area where the EPT sealer will attach. Using isopropyl alcohol on a shop towel, thoroughly clean the area. 4. Trial fit the door visor to the door, and note the position that the EPT sealer needs to be installed in to seal and prevent wind noise. Remove the door visor. Remove the adhesive backing from the EPT sealer and attach it to the door mirror base as shown. 5. Attach masking tape to the ends of the long adhesive backings, and remove 2 to 3 in. (5 to 8 cm) from the ends. Fold back the ends and tape the ends to the front of the door visor. Note the direction of the adhesive backings. Remove the short adhesive backing. 6. Push the three door visor brackets onto the door sash and insert the front tab under the door mirror base. 7. Check that the distance between the rear end of the door visor and front door is about 2 in. (50 mm). 8. While holding light pressure on the door visor, carefully remove the adhesive backing in the directions shown. Using the palm of your hand, hold the door visor firmly against the door for 30 seconds. 9. Reinstall the door glass run channel. Seat the glass run channel properly around the three brackets. 10. Lower the rear door glass completely. Remove the door glass run channel from the door sash in the area shown.