Home Auto Repair 2013 Honda Illuminated Door Sill Trim Installation Instructions

2013 Honda Illuminated Door Sill Trim Installation Instructions

145

Download INSTALLATION 1. Disconnect the negative cable from the battery. 2. Remove the passenger’s under cover (four clips and two pins). 3. Remove the passenger’s door sill trim (two retaining tabs and six clips). 4. Pull away the door opening seal, and remove the passenger’s kick panel (two clips). 5. If equipped, remove the driver’s dashboard under cover (turn the knob and release the two clips). 6. Remove the driver’s dashboard lower cover (nine clips and unplug the vehicle connectors). 7. Using the ignition key, unlock the trunk lid/fuel fill door opener, then remove the ignition key. Remove the key cover (six retaining tabs). 8. Remove one self-tapping screw from the trunk lid/ fuel fill door opener cover. 9. Remove the driver’s door sill trim (two retaining tabs and six clips). 10. Pull away the door opening seal, and remove the driver’s kick panel (two clips). 11. Pull away the door opening seal in the area shown. 12. Attach a piece of masking tape to the vehicle panel in the location shown. 13. Align the left illuminated door sill trim with the masking tape attached in step 12, then attach another piece of masking tape to the vehicle panel along the outside edge of the left illuminated door sill trim. Do not tape down the left illuminated door sill trim. 14. Remove the left illuminated door sill trim. 15. Peel back the adhesive backings, and tape them to the front surface of the left illuminated door sill trim with masking tape. Remove the other adhesive backing. 16. Using an alcohol swab, thoroughly clean the vehicle panel where the left illuminated door sill trim will attach.