Home Auto Repair KTM 690 SM/SMC/SMR Removal & Installation weld slag

KTM 690 SM/SMC/SMR Removal & Installation weld slag

146

Download KTM 690 SM/SMC/SMR/Duke Removal and Installation Weld Slag – 1. Each bike varies with regard to welds and gussets. Review the photos first to get the idea of what needs to be done. 2. These photos may not be your exact model but depict the concept of what must be done. 3. Block the front tire securely before removing the top triple clamp so the tire cannot move at all. See photos. 4. Support the rear tire also, just enough to keep tension on the front tire so the forks stay tight. 5. Warning: Once the triple clamp is loose, the forks can roll away from the bike AND it happens very quickly . 6. The main triple clamp nut adjusts the tension on the steering head bearings. Make note of its tension before removing and do not over tighten the nut. It should be seated just enough to take the play out of the bearing.. 7. The top of the gauge/light cluster is mounted to the top triple clamp. You have to take out 4 self tapping Phillips head screws to remove the gauge pod. There is one connector on the back side of that and then it comes off. Then there are two bolts that need to come out with an 8mm wrench to free the top triple clamp. 8. Loosen the triple clamp pinch bolt under the main nut and forks pinch bolts and remove the top triple clamp, …