Download 2017 Honda Accord (4-door) Door Visors Installation Instructions – Installing the Front Door Visor 1. Fully lower the left front window. 2. Pull down the glass run channel in the areas shown. 3. Install the two brackets A to the door sash at the locations shown. 4. Install the glass run channel to secure the two brackets A. Make sure the brackets are installed on the door sash as shown, and that the glass run channel is installed properly. 5. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the left front door visor will attach. 6. Attach a piece of masking tape to the end of the adhesive backings as shown. Peel back the adhesive backings partway and temporarily attach them to the front surface of the left front door visor. 7. Align the holes in the two brackets A to the two holes in the left front door visor. 8. Secure the left front door visor to the two brackets A with two clips. Push on the brackets while installing the clips.