Home Auto Repair 2000 Jeep Cherokee Alternator: Service and Repair REMOVAL

2000 Jeep Cherokee Alternator: Service and Repair REMOVAL

92
Download WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WERE (B+ WIRE) FROM GENERATOR. FAILURE TO DO S0 CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM. 1. Disconnect negative battery cable at battery. 2. Remove generator drive belt. 3. Left Hand Drive (LHD) Vehicles Only: Remove generator pivot and mounting bolts/nut. Position generator for access to wire connectors. 2000 Jeep Truck Cherokee 2WD L6-4.0L VIN S 4. Right Hand Drive (RHD) Vehicles Only:Remove upper nut (generator adjustment nut) and both belt adjustment bolts. Remove generator lower nut/bolt. Position generator for access to wire connectors. 5. If equipped, unsnap plastic cover from B+ terminal. 6. Remove B+ terminal mounting nut at rear of generator.Disconnect terminal from generator. 7. Disconnect field wire connector at rear of generator by pushing on connector tab. 8. Remove generator from vehicle. INSTALLATION 1. Position generator to engine and snap field wire connector into rear of generator. 2. Install B+ terminal to generator mounting stud. Tighten mounting nut to 8.5 Nm (75 in. lbs.) torque.