Home Auto Repair 2004-2005 Mitsubishi Lancer Ralliart Manual Transmission COLD AIR INTAKE SYSTEM Installation Instructions

2004-2005 Mitsubishi Lancer Ralliart Manual Transmission COLD AIR INTAKE SYSTEM Installation Instructions

65
Download 2) Removing the stock air inlet system a) Before removing any of the O.E. components, label each individual part so that no components become mixed up during the installation process. b) Remove plastic intake duct from the front of the engine by removing the plastic clips and pulling the duct straight forward. To remove the clips, use a pointed device and push in the middle of the clips. Throttle Cable c) Remove the breather hose from the valve cover by pulling it off. d) Unclip the throttle cable from the side of the air filter housing. 3 e) Unclip the Mass Air Flow (MAF) sesnor wiring harness from the air filter housing. These clips can be removed undamaged from the harness using a small flat head screwdriver. f) Unscrew the Inlet tube from the throttle body and pull the inlet tube off the throttle body. g) Unplug the MAF sensor from the engine harness. h) Remove the two bolts securing the stock air filter housing to the engine bay. Remove the air filter housing and the inlet tube. i) Remove the two bolts securing the MAF sensor to the air filter housing and remove the MAF sensor. Be careful not to damage the sensor. j) Unclip the wiring harness from the air box bracket behind the batery.