Home Auto Repair 2010-2011 Hyundai Elantra Touring BX2328 Manual Installation

2010-2011 Hyundai Elantra Touring BX2328 Manual Installation

92

Download Tools Required 8MM Socket Drill 10MM Socket Phillips Screwdriver 14MM Socket Utility Knife 7/16″ Socket/Wrench Pliers 9/16″ Socket/Wrench Tape Measure 3/4″ Socket/Wrench 1 1/4″ Hole Saw Large Vise Grip 13/32″ Drill Bit Needle Nose Pliers 5/16″ Drill Bit Reciprocating Saw 17/32″ Drill Bit Installation Instructions: 1. Using a Phillips screw driver, remove fi ve plastic pus pins from the top front of the fascia. Set pins aside to be reinstalled later. Do this to both sides of the vehicle. 2. Using a 10MM socket, remove two metric bolts from the air intake housing. Set bolts aside to be reinstalled later. 3. Using a 8MM socket or a Phillips screwdriver, remove one screw just forward of the front tire, on the wheel well. Do this to both sides of the vehicle. Set screws aside to be reinstalled later. 4. Using a 10MM socket, remove fi ve metric bolts from the belly pan underneath the vehicle. Set belly pan and bolts aside to be reinstalled later. 5. Using a Phillips screwdriver, remove three plastic Phillips pushpins from just forward of the front tire along the bottom edge of fascia. The fascia is then ready to be removed from the vehicle by pulling fascia ends out to the side to release and then pulling it forward. Do this to both sides of the vehicle. Set fascia and pushpins aside carefully to be reinstalled later. 6. On the passenger side moving from top right clockwise, remove the wire clips from the top tab to release the wires. Using a 10MM socket remove two metric bolts, one on each side.