Home Auto Repair Honda VTX 1300 BA-2061-00 BAK (Big Air Kit) Installation

Honda VTX 1300 BA-2061-00 BAK (Big Air Kit) Installation

107

Download INCLUDED IN THE KIT: (1) Billet BAK Cover (1) M6 x 60 Socket Cap Screw (1) M5 x 10 Socket Cap Screw SS (1) M6 Fender Washer (5) M6x12mm Phillips Head Stainless Screws (1) 1/4″ x 1 1/2″ Plastic Spacer, Black (3) M5 x 16 Flat Head Screw (2) 1/4″ Lock Washer (2) 1/4-28 x 1 13/16″ Hex Bolt Zinc (1) Jet Kit BA-2461-00 (1) BAK Backing Plate VTX 1300 (2) Aluminum Filter Spacer (1) Reed Valve Block Off Kit BA-2561-00 (1) Filter Raincoat (1) Re-useable Performance Air Filter TOOLS REQUIRED: Shop Manual 3, 4, & 5mm Allen Wrenches 7/16″ Open End Wrench #2 Phillips Screw Driver. INSTRUCTIONS: 1. Remove fuel tank according to Honda service manual procedures. 2. Remove air cleaner from right side of bike. 3. Remove idle cable holder from back of stock air filter. 4. Install idle cable holder to rear of the new BAK backing plate just below the nylon nipple. Bracket should face outward and slightly down when BAK is mounted. 5. Install Jet Kit according to instructions provided in Jet Kit box. 6. Install Reed Vale Black-off Kit using the instructions provided with that kit. Installation of this kit is optional. 7. Place 1/4-28 x 1 13/16″ Zinc Hex Bolts & 1/4″ lock washers into center holes of backing plate from the backside. It may help to use some masking take to hold them in place. 8. Install new backing place to carburetor and secure with three flat-head screws provided (blue Loctite is recommended).