Home Auto Repair 2000-2002 Audi TT Part RD3025p Cold Air Intake System

2000-2002 Audi TT Part RD3025p Cold Air Intake System

75

Download Note: Disconnect the negative battery terminal before starting this installation. 1. Remove the air intake box and air intake duct that leads to the mass air flow sensor. 2. Slip the 2 3/4″ straight hose over the mass air flow sensor use two clamps and tighten the clamp on the mass air flow sensor. (See fig. 2) 3. Take the vibra-mount and screw it into the bracket located on the side of the strut tower mount. (See fig. 3) Removing the head lamp and the front bumper. 4. Remove the 3 m6 bolts located on the extended plastic arms on the head lamp. (See fig. 4) You will also disconnect the three harness clips located on the back side of the head lamp. (See fig. 5) 5. In order to remove the bumper you need to peel back the splash guards in the wheel well. Unscrew two m6 nuts on each side of the frame located behind the splash guards. (See fig. 6) The nuts are screwed into the two studs located on each side of the bumper. (See fig. 7) Remove the plastic clips located over the front grill and underneath the bumper splash guard. Unscrew the screws on the bumper one located on each side of the top corner behind the wheel well splash guard and carefully remove the bumper (See figs. 4 and 7) 6. Carefully remove the HID ballast from the stock location. Take an allen wrench and remove the bolt on the back side of the pad. Take the 3025 bracket in this kit and place it in postion replace the bolt back to its original location. (See fig. 8) Note: Some late model cars have the HID ballast built into the head lamp no changes are required.