Home Auto Repair 1997-2006 Jeep Wrangler TJ Tint Sides and Rear Curtain

1997-2006 Jeep Wrangler TJ Tint Sides and Rear Curtain

108

Download Install Windshield Brackets Loosen the top screw on the A-Pillar Molding. Use a #40 Torx Driver to remove the outboard bolt that attaches the Sport Bar to the windshield. Slide the Windshield Bracket behind the A Pillar Molding and reinstall the bolt you removed to secure the bracket to the windshield. Re-tighten the top molding screw. Install Tailgate Retainers Locate the left and right Tailgate Retainer Mounts. Place the mounts fl ush with the edge of the tailgate opening. Install the Tailgate Retainer Mounts with two #8 x 1/2″ Pan Head Washer Screws for each mount. If your vehicle does not have holes at this location, align the Tailgate Retainer Mounts fl ush with the edge of the tailgate opening. Then mark the locations of the holes in the mounts, center punch and drill a 1/8″ hole at the marked locations. Install the mounts with two #8 x 1/2″ Pan Head Washer Screws for each mount. Install Bow Mount Brackets Locate the Left and Right Bow Mount Brackets in the parts kit. Locate the brackets behind the door opening on top of the body, with the curved Vertical Rod Retainer toward the front and opening to the inside of the vehicle. Align the holes in the bracket with the existing holes in the vehicle. Place a Tapping Plate under the ledge, lined up with each hole and install a 5/16-18 x 1″ Phillips Head Bolt and a 5/16″ Washer. Door Opening Front Vertical Rod Mount Outside of Vehicle Tapping Plates