Home Auto Repair 2003 Honda Accord 4-Door Accessories Fog Light Installation

2003 Honda Accord 4-Door Accessories Fog Light Installation

71

Download TOOL AND SUPPLIES REQUIRED #2 Phillips screwdriver Small flat-tip screwdriver Felt-tip pen 10 mm Combination wrench 10 mm Socket Ratchet Measure 3 mm and 7 mm Drill bits Eye protection (face shield, safety goggles, etc.) File Diagonal cutters 20 mm Hole saw Drill Masking tape Thumbtack Drill stopper Scissors Hacksaw blade. INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your car. These procedures should not be attempted by “do-it-yourselfers.” 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. Installing Fog Lights 3. Install the left trim to the left bracket A with two 4 x 16 mm self-tapping screws. 4. Install the left fog light to the left trim with the one step-screw (with rubber), step-screw and washer- screw. 5. Repeat steps 3 and 4 to install the right fog light. Cutting the Front Bumper. 6. Using the scissors, cut out template A. Position template A on the front bumper as shown, and mark the bumper at each of the two marks indicated on template A with a felt-tip pen. 7. Remove template A. 8. Align template B with the marks you just made, and mark the bumper at the two marks indicated on template B with a felt-tip pen.