Home Auto Repair 2000 Hyundai Tiburon BX2310 Manual Installation

2000 Hyundai Tiburon BX2310 Manual Installation

76

Download 2000 Hyundai Tiburon BX2310 Manual Installation Instructions Tools Required 8MM Wrench 9/16″ Wrench Loctite3/8″ Drill Bit 14MM Wrench Needle Nose PliersPhillips Screw Driver. Installation Instructions : 1. Remove the lower screw from the bottom of the bumper facia. Figure 1. 2. Looking up to the back side of the front grill, remove the phillips screw and 10mm Hex bolt just above the phillips screw. Figure 2 and 3. 3. Remove the push pins and screw forward of the front tires. Figure 4. 4. Open the hood and remove the screw on top of the head light assembly. Figure 5. Pull the assembly out and remove the Hex nut holding the bumper facia. Figure 6. 5. Remove the push pins from the top of the bumper facia, remove the top molding and pull facia from the vehicle. Figure 7. 6. Remove the Hex bolts from the sides of the frame and the Hex bolt from the lower cross member (drivers side). Bolt the baseplate to the frame and cross member using same bolts. Figures 8. 7. Drill a 3/8″ hole for the passengers side brace and use 3/ 8″ hardware to fasten to frame. Tighten all bolts according to the chart in the General Instruction Sheet. Figure 9. The 3/8″ nut plate can be inserted through the large opening in the cross member. Figure 10. 8. Replace the bumper facia and head lights. The 10mm bolt that is removed in step 2 will not be replaced.