Home Auto Repair Honda CR-V XM RADIO INTERFACE Installation Intructions

Honda CR-V XM RADIO INTERFACE Installation Intructions

95

Download PARTS LIST XM Radio Unit Kit (sold separately): P/N 08A15-EX5-000 XM Radio unit XM Radio Antenna Kit (sold separately): P/N 08A15-EX5-100A XM Radio antenna XM Radio Attachment Kit (sold separately): P/N 08B15-S9A-100 XM Radio bracket A XM Radio bracket B Wire tie 2 Wire tie with clips EPT sealer 2 Washer-bolt, 6 x 12 mm 7 Cushion tapes 4 Screws, 5 x 8 mm 4 Washers TOOL AND SUPPLIES REQUIRED Phillips screwdriver Flat-tip screwdriver Isopropyl alcohol Shop towel 10 mm Combination wrench Clip remover Diagonal cutters Ratchet wrench 10 mm and 14 mm socket Scissors INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery. 3. Open the tailgate. 4. Fold down the rear seat-back, then fold the rear seat assemblies forward. 5. Fold the cargo area mat forward, and remove the cargo area floor. Remove the cargo storage bin. 6. Remove the two front clips from the rear trim panel. Pull up on the rear trim panel to release the five clips. 7. Remove the left rear door sill trim (three clips). 8. Release the two retaining tabs, and pull the accessory socket.