Home Auto Repair Honda ST 1300 Dual Rear Kit Installation Instructions

Honda ST 1300 Dual Rear Kit Installation Instructions

75

Download Introduction: Made in USA This easy to install, high quality, Powerlet™ kit provides a convenient way to access the battery on Honda ST1300 motorcycles. The operator can supply power to the battery (i.e. battery charger), draw power from the battery (i.e. heated clothing, cell phone), or monitor the state of charge on the battery using the Powerlet socket. Parts List: • 1 – Wiring harness w/ 15A fuse • 1 – Bracket w/ 2 Powerlet sockets • Ty-wrap(s) Please read all of the instructions carefully before attempting the installation of this product. Please have a trained professional install this kit if you are unfamiliar with these procedures. Quick Start Instruction: STEP #1 Remove the seat and the panels from both the right and left sides. STEP #2 Install & route harness. STEP #3 Attach the wires to the sockets and test. STEP #4 Attach the socket bracket to the rear shock adjuster. STEP #5 Reinstall seat & panel. Detailed Instruction: STEP #1 – Expose the battery by removing the seat & side panels on both sides of the bike. See the Honda service manual. STEP #2 – Stretch out the wiring harness. Using a ty-wrap, attach the fuse holder to the stock vehicle wiring harness [D] located on the right side of the battery. Next remove the negative battery connection, followed by the positive battery connection. Slip the red wire under the red battery boot [C]. You may need to trim the red boot to accommodate the added wire. Connect the red wire to the battery posts as follows: