Home Auto Repair 2008 Honda TRX700XX Installation Instructions

2008 Honda TRX700XX Installation Instructions

75

Download 2008 Honda TRX700XX Installation Instructions Parts List 1 Power Commander 1 USB Cable 1 CD-ROM 1 Installation Guide 1 Power Adapter 2 Power Commander Decals 2 Dynojet Decals 2 Velcro Strip 1 Alcohol Swab. PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION 1 Remove the seat. 2 Remove the rubber cover and the plastic cover over the battery and throttle body (Fig. A). 3 Unplug the stock wiring harness from the injector (Fig. B). This is the GREY 2 pin connector on top of the throttle body. 4 Unplug the stock wiring harness from the Throttle Position Sensor (Fig. B). This is the BLACK 5 pin connector on the lower left side of the throttle body 5 Route the PCIIIharness thru the rubber cover as shown in Figure C. 6 Connect the PCIII harness in-line of the stock wiring harness and injector (Fig. D). 7 Crimp the supplied wire tap on to the YELLOW/BLUE wire of the TPS connector (Fig. E). 8 Attach the GREYwire from the PCIII to the wire tap (Fig. E). It is recommended to use dielectric grease on these connections. 9 Plug the TPS connector back onto the throttle body. 10 Attach the ground wire of the PCIII to the negative side of the battery. 11 Reinstall the plastic and rubber covers that were removed in step 2. 12 Lay the PCIII on top of these covers. The seat will keep the PCIII in place. 13 Reinstall seat. Make sure to install the port plugs into the PCIII.