Home Auto Repair 1999-2003 Ford F-Series 7.3L PowerStroke Edge Juice Module

1999-2003 Ford F-Series 7.3L PowerStroke Edge Juice Module

69

Download Edge Module and Sensor Wire Installation For trucks with fuse box in a different location, an alternate location for mounting will have to be found. One suggestion is to mount the Juice Module on the side of the air filter box. 1. It is strongly recommended when installing electrical devices that both batteries should be disconnected. Use a 13 mm or 8 mm wrench depending on battery style and remove the negative terminal cable end from each battery. 2. Place the Juice module on top of the fuse box as shown in figure 5. After the installation is complete you will use the supplied Velcro® to secure the Juice module to the fuse box. 3. Connect the MAP “Y” connector between the wire harness and the sensor as shown in Figure 6. This connection is located in front of the passenger side of the vehicle in the engine compartment. 4. Connect the MAT “Y” connector between the wire harness and the sensor as located in Figure 7 NOTE: Pay special attention to the location of the MAT sensor – It is located BELOW the waste gate control solenoid and is a sensor THREADED into the intake manifold. 5. Connect the ICP “Y” connector between the wire harness and the sensor as shown in Figure 8. 6. Routing the Cam Position Sensor (CMP) There are many possible routes for the CMP cable. The preferred method is to remove the plastic “Powerstroke” cover and route the wire for the CMP sensor across the top of the engine as shown in Figure 9 along or close to the factory wiring.