Home Auto Repair 2006 Honda Pilot Wood-Grain Steering Wheel Installation

2006 Honda Pilot Wood-Grain Steering Wheel Installation

76

Download TOOLS REQUIRED Phillips screwdriver 10 mm Combination wrench Flat-tip screwdriver 19 mm T-handle wrench Torque wrench Steering wheel puller T30 and T40 Torx bits INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” NOTE: After installing the wood-grain steering wheel, you must align the steering wheel spoke angle to the straight ahead position by adjusting the front toe. 1. Make sure you have the anti-theft code for the radio, then write down the radio station presets. 2. Disconnect the negative cable from the battery, and wait for at least 3 minutes before you start to install the wood trim steering wheel. 3. Pry up on the retaining tabs, and remove the access panel from the underside of the driver’s side airbag. 4. Remove the airbag connector from the boss plate cover. Unplug the airbag connectors; while holding the pin insulator, pull out on the cover insulator. Do not pull on the socket insulator. 5. Remove and discard the two Torx bolts that secure the airbag, and remove the airbag. Carefully set the airbag in a secure location with the pad facing up. Do not drop or bump the airbag against anything. 6. Turn the steering wheel so the front wheels are in the straight-ahead position.