Download Before starting installation. 1. Carefully read all warnings and instructions completely before beginning. 2. Verify all parts have been received in this kit by checking parts list at the end of this document. 3. Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what is outlined in the instructions, call technical support at (928) 636-7080 4. Special tools needed: a. Coil spring compressor 5. Park the vehicle on a clean, dry, flat, level surface and block the tires so the vehicle cannot roll in either direction. 6. Disconnect both battery cables. a. Disconnect negative cable first, then positive cable from battery. NOTE Kit parts are prefaced by the word kit and appear in bold print. NOTE If parts are missing from kit, be prepared to provide the following information: 1. Name of purchase location 2. Bar Code on side of box 3. Date above bar code 4. Date inside box cover 5. Inspector # from inside box cover WARNING Compressed coil springs can expand quickly and cause serious personal injury. Use extreme caution when working with compressed springs. Positive Cable Negative Cable. Prepare to install kit A. Front of Vehicle. 1. Front Wheels a. Remove two center wheel caps from two front wheels. b. Loosen five lug nuts each from two front wheels. c. Position hydraulic jack under center of axle frame crossmember. Slowly lift front tires off ground three to five inches.