Download VTX1300C VTX1800C/F Backrest/Rear Carrier Manual Installation Application : Honda VTX1300C and Honda VTX1800C/F. Accessory : SPORT-CUSTOM STYLE BACKREST/REAR CARRIER MOUNTING BRACKET P/N 08F75-MCH-300A. TOOLS AND SUPPLIES REQUIRED Socket (12 and 14 mm) Ratchet Box-end wrench (12 and 14 mm) Hex wrench (5 and 8 mm) Isopropyl alcohol Shop towel Ruler Torque wrench TORQUE CHART Tighten all screws, bolts and nuts to their specified torques. Refer to the Service Manual for the tightening torques of removed parts. INSTALLATION : VTX1800F only from step 1 to 4. 1. Remove the reflex reflector from the rear fender. 2. Remove the double-sided adhesive tapes from the reflex reflector you just removed. 3. Using an isopropyl alcohol solution, thoroughly clean the left rear side of the rear fender where the reflector will be attached. Attach the reflex reflector to the rear fender in the area shown. 4. Repeat on the right side. 5. Assemble the right and left carrier stays with the carrier plate as shown. 6. Install the backrest pad (sold separately) on the backrest bar (sold separately) as described: 7. Loosely install the left backrest stay. 8. Repeat on the right side.