Download 2006 Honda Civic Coupe Xenon Projector, Xenon Foglight and Clear Corners Installation Guide The following are my instructions for successfully installing xenon projectors in a 2006 Honda Civic Coupe. The process would be very similar for the Sedan or the Si, and could be easily modified for those models. Also included in this installation are instructions for installing xenon bulbs and ballasts in the Honda OEM foglights (if you have them installed on your Civic) as well as performing a clear corners modification (i.e. removing the diffusers). Since the clear turn signals modification also requires disassembly of the headlights, it makes sense to do it at the same time. Headlight Assembly Removal Now that the bumper has been removed, the bolts that secure each headlight assembly are accessible and can be removed, along with the headlights themselves. There are four identical 10 mm bolts securing each headlight assembly, but there is one additional bolt (identical to the other four) and one body-colored bolt on each side that both need to be removed in order to get the assemblies out of the car (also 10 mm). 3.1 Begin by removing the two upper bolts. They are easily accessible, as shown in Figure 3-1. Also shown is the body-colored bolt that can also be removed now. Figure 3-1: Three of six bolts to remove for removal of the headlight assembly 3.2 Also remove the bolt on the side, near the turn signal (“A” in Figure 3-2) and the one underneath (Figure 3-3), which will require the socket extension to reach.