Home Auto Repair 2005 Honda CR-V Moonroof Visor Installation Instructions

2005 Honda CR-V Moonroof Visor Installation Instructions

67

Download 1. Clean and wax the area to be covered with a high-quality paste wax. 2. Open the moonroof. 3. Using isopropyl alcohol on a shop towel, clean the areas where the EPT sealer will attach. 4. Remove the adhesive backing from the EPT sealer, and attach it to the roof in the area shown. 5. Insert a Phillips-head screw through each of the holes on the top of the visor; loosely install the clips and self-locking nuts. 6. Set the moonroof visor on the vehicle’s roof, forward of the moonroof opening, and adjust its position so it is equally spaced on all sides. 7. Attach a short strip of masking tape to both sides of the vehicle’s roof ahead of the point where the clips will attach to the moonroof opening. Remove the visor. 8. Using isopropyl alcohol on a shop towel, clean each corner where the protective tapes will attach; then remove the adhesive backing from one of the protective tapes, and attach the tape to the lip and underside of the moonroof opening, in line with the masking tape. Be sure the tape just touches the inner lip on the underside of the moonroof opening. 9. Repeat step 8 to install the protective tape on the on the other side of the moonroof opening. Remove the masking tape. 10. Reposition the moonroof visor over the moonroof opening. Check again for equal spacing. While holding the moonroof visor in place, hook the clips between the inner lip and the outer lip of the moonroof opening at the taped locations.