Home Auto Repair 2012 Honda CR-V Moonroof Visor Installation Instructions

2012 Honda CR-V Moonroof Visor Installation Instructions

76

Download INSTALLATION NOTE: • Do not damage the paint finish when you install the moonroof visor. • The moonroof visor should only be installed if the ambient air temperature is 15°C (60°F) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Please advise your customer. Installing the Moonroof Visor 1. Clean and wax the area to be covered with a high-quality paste wax. 2. Open the moonroof. Roll up two shop towels, and insert them between the roof panel and air deflector to lower the air deflector. Take care not to damage the air deflector. 4. Using isopropyl alcohol on a shop towel, clean the roof area where the protective tape will attach. Do not wipe off the mark. 5. Remove the adhesive backing from one protective tape, and attach it to the right side of roof panel from the mark. Wrap 10 mm (0.4 in.) of protective tape around the lip of the moonroof opening. Remove the mark. 6. Repeat steps 4 and 5 to install the protective tape on the left side of moonroof opening. 7. Locate the third indentation in from right side of the moonroof opening as shown. Using isopropyl alcohol on a shop towel, clean the roof area where the protective tape will attach. 8. Remove the adhesive backing from one protective tape. Starting at the top edge, install the protective tape at the third indentation in from right side of the moonroof opening. 9. Repeat steps 7 and 8 to install the protective tape on the left side of moonroof opening.