Home Auto Repair 2004 Acura TSX Rear Big Brake Kit Installation Instructions

2004 Acura TSX Rear Big Brake Kit Installation Instructions

62

Download Step 1 Raise Vehicle, and Remove Wheels Raise Vehicle, and Remove Wheels Raise Vehicle, and Remove Wheels Raise Vehicle, and Remove Wheels Raise Vehicle, and Remove Wheels For a rear kit installation, block the front wheels, and release the parking brake. Then break loose the lug nuts on both rear wheels before jacking up the car. Refer to the Owner’s Manual to identify the correct location of the jack for raising the vehicle. Jack up the vehicle, and secure it on a pair of jack stands, again referring to the Owner’s Manual for jack location joints. After securing the vehicle at a convenient height, remove the rear wheels. Step 2 Disconnect Stock Brake Line Loosen the hard line fitting from the stock brake line, using a 10mm flare wrench. Place a drip tray or several rags directly below the inboard brake line connection. If the area around the brake line connection to the chassis is dirty, clean it using brake cleaner or an appropriate cleaning agent. Remove the metal spring clip holding the stock brake line to the chassis bracket, using needle- nose pliers or a screwdriver, taking care to retain the clip for later use. Remove the hard line fitting, and place one of the rubber caps over the end of it, to control fluid loss during the installation. Warning: Brake fluid will damage most painted surfaces. Immediately clean spilled brake Warning: Brake fluid will damage most painted surfaces. Immediately clean spilled brake Warning: